cisco final 11-21

1.

1 point

What is the term for the value 2172416 that is highlighted in the output of the show ip eigrp topology command?

feasible distance of the successor

reported distance of the successor

feasible distance of the feasible successor

reported distance of the feasible successor

2.

1 point

Refer to the exhibit. RIPv2 is configured in the network shown. Hosts in the network have access to all internal networks but do not have Internet access. On which router should the commands, shown in the exhibit, be added to provide Internet access for all hosts in the network?

R1

R2

R3

ISP

3.

1 point

What do companies gain from the services performed at the enterprise edge?

faster communication with server farms

stronger security against malicious attacks

faster communication with Internet destinations

enhanced performance and reliability through VLANs and redundant trunk links

4.

1 point

Refer to the exhibit. A network administrator wishes to deny Internet access to all R2 LAN hosts, while allowing these hosts to reach all other devices on the company networks. Where the ACL shown in the exhibit should be placed to meet these requirements?

R2: Fa0/0 inbound

R1: S0/1/0 outbound

R1: S0/0/1 inbound

R2: S0/0/1 outbound

R2: Fa0/0 outbound

5.

1 point

Refer to the exhibit. In what sequence (from first to last) does an OSPF router check the parameters listed when selecting the DR?

C, B, A, D

D, C, B, A

A, B, C, D

A, C, B, D

B, C, A, D

6.

1 point

What two statements are true regarding EIGRP tables? (Choose two.)

A feasible successor route can be found in the topology table.

A successor route can only be found in the routing table.

The topology table shows whether a route is in the passive or active state.

The routing table shows the amount of time elapsed since a router adjacency was formed.

The neighbor table shows all adjacent Cisco devices.

Administrative distance is shown as a column in the neighbor table.

7.

1 point

Refer to the exhibit. Assuming that all three routers are configured with the EIGRP routing protocol and sharing information, what information can be gathered from the show command output?

Router B has EIGRP adjacencies with both router A and C.

Router B has a fully converged topology table.

Router B has not formed an adjacency with router A.

Router B has not formed an adjacency with router C.

8.

1 point

Which three statements are true about RSTP? (Choose three.)

RSTP can fall back to STP to provide support for legacy equipment

RSTP and STP have the same number of port states.

Like PortFast and UplinkFast, RSTP is a proprietary protocol.

RSTP takes up to 50 seconds to converge.

RSTP requires a point-to-point, full-duplex connection

RSTP views all ports that are not discarding as part of an active topology.

9.

1 point

Refer to the exhibit. A network support technician has been asked to set an IP address on one of the FastEthernet interfaces on a new router. What is causing the interface to reject the address?

The IP address is already in use.

The technician is using a network address.

The technician is using the wrong subnet mask for /26

The technician must enable VLSM on the interface.

10.

1 point

Refer to the exhibit. A network administrator enters the command ip route 10.10.4.16 255.255.255.248 s0/0/1 into the router. What will be the result of this configuration?

A static route pointing to 10.10.4.16/29 is placed into the routing table.

A static route to 10.10.4.16/29 is placed into the routing table if interface FastEthernet0/1 goes down.

A static route pointing to 10.10.4.16/29 is only placed into the routing table if the route to 10.10.4.0 is removed.

A static route is not placed into the routing table because a RIP route that includes the destination network already exists.