2a656 V1

1.

1 point

(018) If your skin comes in contact with LIN, you should

attempt to rewarm the skin.

cover the effected skin immediately.

seek medical attention immediately.

run cold water over the affected area.

2.

1 point

(004) The three phases of the operational events subsystem of IMDS are

mission tracking, data recording, and retrieval.

input, output, and archive.

on-line, off-line, and update.

mission recording, mission accomplishment, and analysis.

3.

1 point

(020) Which area of a LRU is most susceptible to ESD damage?

Connector pins.

Case.

Wiring

Connector plug.

4.

1 point

(008) Which TO explains the material deficiency reporting system?

00-25-195

00-5-15.

00-35D-54.

00-25C-234

5.

1 point

(015) Revisions are issued when changes exceed what percentage of the basic TO?

50

80

60

70

6.

1 point

(025) Which type of nuclear radiation is the most deadly?

Gamma.

Alpha.

Beta

Delta.

7.

1 point

(025) High-frequency radiation is not produced by

nuclear weapons.

electronic counter-measures equipment.

radio equipment.

radar equipment.

8.

1 point

(024) Which AFI governs safety investigations and reports?

AFI 91-102.

AFI 91-204.

AFI 21-101.

AFI 21-210.

9.

1 point

(016) Which deficiency report is used for a TO deficiency that involves safety or the unit
mission?

Routine.

Urgent.

Interim

Emergency.

10.

1 point

(023) What is considered to be a safe distance in front of jet engine intake ducts?

25 feet.

15 feet.

10 feet.

20 feet.

11.

1 point

(017) When servicing a low-pressure oxygen system, set the regulator valve at a maximum pressure in psig of

485 psig

475 psig

500 psig

480 psig

12.

1 point

(014) While troubleshooting, you are using a wiring diagram to help you locate a malfunctioning component. After determining which component is faulty, you want to determine its part number. To do this, you would check the wiring diagram’s

reference designator.

numerical index.

line replaceable unit designation.

line replaceable unit index.

13.

1 point

(013) Which TO explains the TO numbering system?

00-5-18.

00-5-1.

00-5-10.

00-5-5.

14.

1 point

(003) Which aircraft maintenance squadron flight consists of crew chiefs?

Aircraft section.

Support section.

Weapons section.

Specialist section.

15.

1 point

(005) AFTO Form 244 is used to document discrepancies and corrective actions for

aircraft.

equipment.

batteries.

multimeters.

16.

1 point

(015) Safety supplements to TOs are identified with a border of

black SSs on all pages.

red SSs on all pages.

black SSs on the title page.

red SSs on the title page.

17.

1 point

(019) What type of tasks may you perform in the immediate area of explosives?

Routine.

None

Core.

Mission critical.

18.

1 point

(005) Which AFTO 781 series form provides the overall flight status, or condition of the aircraft?

781 J.

781 H.

781 K.

781 A.

19.

1 point

(003) Which specialty is not part of the accessory maintenance flight?

Pneudraulics

Survival equipment.

Fuels systems.

Egress.

20.

1 point

(024) Which AF Form is used to report ground safety accidents involving personnel (not involving aircraft)?

AF Form 711.

AF Form 711B.

AF Form 117.

AF Form 117B.

21.

1 point

(015) Safety and operational supplements to TOs should be filed in

reverse numerical sequence behind the basic TO.

reverse numerical sequence in front of the basic TO.

numerical sequence in front of the basic TO.

numerical sequence behind the basic TO.

22.

1 point

(013) In the basic TO numbering system, what is the minimum groups of numbers each TO will
have?

Four

Two.

Five.

Three.

23.

1 point

(001) An important key to mission success is

new weapons systems.

educated personnel.

high-tech equipment.

a sound training program.

24.

1 point

(011) CDCs are an example of

a specialized publication.

an Air Force pamphlet.

a recurring publication.

a standard publication.

25.

1 point

(007) The primary responsibility for formal UGT rests with

the commander.

the supervisor.

training management personnel.

the individual.

26.

1 point

(010) Air Force property responsibility is imposed by law on

commanders only.

commanders and supervisors only.

all military and civilian employees.

all military employees.

27.

1 point

(006) The five authorized inspection concepts used by the Air Force are

major, minor, phase, isochronal, postflight.

periodic, phase, isochronal, programmed depot maintenance, airline/manufacturer maintenance.

periodic, home station, postflight, isochronal, programmed depot maintenance.

major, minor, shop, home station, postflight.

28.

1 point

(005) What determines a Red X “unsafe for flight” discrepancy?

The removal of a component that affects safe operation of the equipment.

An inspection or operational check is due.

Upon receipt of a routine action TCTO.

An unknown condition.

29.

1 point

(017) How far away from parked aircraft should LOX carts be stored?

75 ft

25 ft

100 ft

50 ft

30.

1 point

(008) If you fill out a Category II, Product Quality Deficiency Report for a defect in workmanship
then you must forward the draft to the originating point within

1 workday.

4 workdays.

3 workdays.

2 workdays.

31.

1 point

(014) The “XD” in fault isolation code 33-10-XD-02 identifies the

system.

location.

specific fault.

subsystem.

32.

1 point

(012) Which TO explains how to maintain and inspect a particular weapons system?

Operations and Maintenance.

Time Compliance.

Abbreviated.

Methods and Procedures.

33.

1 point

(018) Liquid nitrogen must be stored below what minimum temperature to remain in a liquid
state?

–325.8°F

–320.8°F

–310.8°F.

–315.8°F

34.

1 point

(010) An airman who signs out a toolbox assumes which type of property responsibility for that
toolbox?

Individual.

Supervisory.

Command.

Custodial.

35.

1 point

(014) The MIDAS page number is

a two-digit numbering system expressed as one element of two digits.

a six-digit numbering system expressed as three elements of two digits each.

a two-digit numbering system expressed as two elements of two digits each.

an eight-digit numbering system expressed as four elements of two digits each.

36.

1 point

(004) IMDS training management subsystem can be used to monitor

upgrade training.

optional training.

seasonal training.

qualitative training.

37.

1 point

(004) Three general functions of IMDS are

updating, retrieval, and reporting.

reporting, maintenance, and training.

maintenance, storage, and reporting.

reporting, retrieval, and training.

38.

1 point

(016) How many hours do personnel at the ALC activity have to act upon receipt of an emergency
AFTO Form 22 report?

24

48

36

72

39.

1 point

(020) How much electrical current does it take to cause muscle paralysis?

.001 amps.

.010 amps.

.015 amps.

.005 amps.

40.

1 point

(026) Which safety standard of the nuclear surety program includes a pre-task briefing?

Prevent unauthorized or accidental actions.

Weapons security.

Individual responsibilities.

Prevent nuclear explosions.

41.

1 point

(002) The first-line manager and supervisor of maintenance production is the

squadron commander

maintenance superintendent.

flight commander.

section chief.

42.

1 point

(005) When a malfunction is entered on a maintenance form, who determines the correct symbol to use?

Maintenance officer.

Production superintendent.

Your supervisor.

Individual making the entry.

43.

1 point

(022) Which Air Force publication is a source of information for the prevention of accidents?

AFI 91-202.

AFI 91-204.

AFR 39-1.

AFR 8-2.

44.

1 point

(010) What types of property responsibility can be charged to DOD personnel?

Individual and custodial.

Supervisory and custodial.

Command and supervisory.

Command and custodial.

45.

1 point

(011) What type of publications is similar to an AFMAN but is not as thorough?

Recurring.

Air Force pamphlets.

Specialized.

Air Force instructions.

46.

1 point

(021) Which element must be included in a workplace written hazard communication program?

Hazardous waste disposal procedures.

Hazardous material inventory.

List of health hazards from the chemicals in the section.

Telephone number of hazardous material monitor.

47.

1 point

(013) The first number group within a TO number identifies the

kind of TO.

TO category.

section of the TO.

specific equipment.

48.

1 point

(021) What is the minimum information required on a hazardous chemical inventory?

Name and location of the material.

Name, location, and quantity of material authorized.

Name of the material.

Name, location, and detailed ingredient list of the material.

49.

1 point

(008) The main source of material deficiency information is found in

DD forms

applicable specifications.

IMDS.

regulations.

50.

1 point

(003) Which flight is part of a maintenance squadron?

Resources.

Quality assurance.

Test, measurement, and diagnostic equipment.

Maintenance operations and programs.