PowerGen Phase 1

1.

1 point

What size breakers are in the MATS20012?

Generator 100A / Utility 100A

Generator 100A / Utility 200A

Generator 200A / Utility 200A

Generator 200A / Utility 100A

2.

1 point

Which of the following is the most important to load management calculation?

LRA

SA

RA

They all need to be used in the calculations

3.

1 point

If you have a 5 machines that can produce 5 widgets in 5 minutes, how many widgets can 100 machines produce in 5 minutes?

500

100

25

5

4.

1 point

What is the MG070033 (ATS adapter kit)?

An electronic kit that controls the start and stopping of the generator

A device that allows the ATS to be freestanding

Electronic components that allow the ATS to communicate a fault to the generator

Electrical components the send 240v power to the generator

5.

1 point

Which of the following is considered a safety feature of the Air cooled generators?

External fuel solenoid

Synthetic oil

All steel enclosure

Locking lids and doors

6.

1 point

The MG4002001 transfer switch is a true 400A switch.

True

False

7.

1 point

How many Loads can be managed with the SynapSwitch?

8.

1 point

There is a 3rd party conversion kit available that will allow our portable generators to run on propane.

True

False

9.

1 point

The engine in the 8kw – 20kw is a Briggs and Stratton Vanguard

True

False

10.

1 point

How can a customer make the Vigilant switches manage loads?

By using the MATSRM50

By adding the Briggs Load Control Center

All of the above

None of the above

11.

1 point

Which generator controller has an optional remote annunciator?

Intelilite

SynapSwitch

Intelinano

Vigilant

12.

1 point

Liquid cooled generators come standard with a block heater and battery warmer.

True

False

13.

1 point

What is the RPM of the MG20003?

1800 RPM

3600 RPM

4200 RPM

Variable RPM

14.

1 point

Milbank portable generators are certified to UL2200

True

False

15.

1 point

Which voltages are available from the air-cooled generators?

120/240

120/208

139/240

277/480

16.

1 point

What is the proper battery voltage for the Milbank generators?

6v

12v

24v

48v

17.

1 point

Milbank Remote Modules replace what?

Larger generators

The HVAC thermostat

Load Control Center

The wireless monitor

18.

1 point

What size gas pipe should be used for the total run on a air-cooled generator installation?

¾ inch

1 inch

The generator will accept any size of pipe.

It depends on the length of run and gas pressure available.

19.

1 point

You can use Air-Cooled generators for prime power applications

True

False

20.

1 point

What is the maximum distance that the wireless monitor receives a signal from the generator?

150 yards

200 yards

300 feet

200 feet

21.

1 point

What is the purpose of a remote annunciator?

It allows the end user to monitor the generator on their smart phone

It allows the end user to control the generator remotely

It increases the output of a generator

It displays the status of the generator

22.

1 point

When using power management, what is NORMALLY the appliance with the highest current draw?

Gas fired tankless water heater

Pool pumps

Air conditioner unit

Electric Range

23.

1 point

Which are advantages of the Milbank remote modules over the Briggs Load Control Center? Select all that apply

Smaller and easier to install

Modular

Works wirelessly

Works with other brands

24.

1 point

You can use Air-Cooled generators for commercial application

True

False

25.

1 point

What size breakers are in the MG2003002?

Generator 100A / Utility 200A

Generator 200A / Utility 100A

Generator 150A / Utility 200A

None of the above

26.

1 point

Which best describes how our digital inverter generator works?

The microprocessor in the generator communicates with the loads to determine the proper power output.

The AC output coming from the windings is monitored and adjusted by the digital controller for harmonic distortion.

The unit inverts the power so it flows the opposite direction

The unit converts the DC output of the generator to an AC waveform by rapidly switching the power between positive and negative.

27.

1 point

What size Vigilant switches are available in 3 phase configurations? Select all that apply

400A

800A

100A

200A

28.

1 point

The Briggs and Stratton selected circuit switches come with branch breakers installed?

True

False

29.

1 point

Which of the following describes a two wire start system?

A two wire connection on a branch breaker that controls starting of the generator

The generator decides when to start by sensing that the utility is not present

The ATS commands the generator to start by closing a relay on the control board

Two wires connected to the ATS clock that controls the generator

30.

1 point

What device(s) can be used for load shedding on the SynapSwitch?

The SynapSwitch can be wired directly to any load that needs to be managed

Off the shelf contactor

MATSRM50

Load Control Center

31.

1 point

What is the RPM of the MG2000ip

1800 RPM

3600RPM

4200 RPM

Variable RPM

32.

1 point

What size gas pipe should be used for the total run on a 25kw installation?

The generator will accept any size of pipe.

¾ inch

It is dependent on the length of run and gas pressure available.

1 inch

33.

1 point

Which air-cooled generator uses the “Legacy” control board? Select all that apply

MG10002

MG12002

MG20003

MG20002

34.

1 point

Which liquid cooled models use the standard or legacy Briggs controller? Select all that apply

MG2524011BS

Models prior to our current offering

Any configuration of the liquid cooled generators

240v applications

35.

1 point

You can use the wireless monitor for the Milbank 80kw diesel

True

False

36.

1 point

When should the MG070033 (ATS adapter kit) used?

When the switch is designed for a 2 wire start

When using a switch that is not made by Briggs or Milbank

When the switch is designed for an Auto Mains Failure Start

When using any switch that is greater than 7 years old

37.

1 point

Which portable units come standard with the power cord?

MPG55003

MPG6500E

MPG6000S

MPG75002E

38.

1 point

What is the standard required NG gas pressure for our air cooled generators?

3.5 – 5 inches of water column

7 – 11 Inches of water column

5-7 inches of water column

11-14 inches of water column

39.

1 point

Our air-cooled generators can be reconfigured for 3 phase applications

True

False

40.

1 point

Warranty on the liquid cooled engines (25kw-62kw) is 4 years.

True

False

41.

1 point

What size breaker is installed on the 12kw unit?

30A

50A

60A

100A