Finals Part 1

Refer to the exhibit. A two-way redistribution is configured on router R2 between the EIGRP and the OSPF domains. The
show ip route command output taken on R3 reveals that the network 10.10.10.16/28 is not installed in the routing table. What could the problem be?

When the command
distribute-list 1 in serial 0/0
is used, which routing updates would be permitted?

Refer to the exhibit. Assume router R2 does not have BGP enabled. However, the
neighbor remote-as
router configuration commandhas been entered on routers R1 and R3. Based on the information that is presented, which two statements are true? (Choose two.)

During an interview, the company IT manager mentions that the company has two critical communication links to its main supplier.These links require an uptime of 24/7. Which part of the PPDIOO process is most affected by this information?

When would the network administrator use the ip bandwidth-percent eigrp as-number percent command?

What are two significant benefits that are provided by IPsec? (Choose two.)

What are two effective ways to prevent the EIGRP stuck-in-active problem? (Choose two.)

Refer to the exhibit. Routers A and B have EIGRP configured and automatic summarization has been disabled on both routers. Whichtwo router commands should be used to summarize the attached routes, and to which interface is this command applied? (Choose two.)

A network administrator must interconnect a small office/home office (SOHO) in a modern metropolitan city. Which two accesstechnologies would be the most cost effective solutions to implement? (Choose two.)

Which two statements are correct about redistribution? (Choose two.)

What is the best solution for the split-horizon problem in a Frame Relay network?

Which three critical functions are provided by VPNs? (Choose three.)

Refer to the exhibit. How is the OSPF default gateway entry determined for R2?

In the design of a network that will be based on the Cisco Enterprise Architecture, which two items would be included in the enterpriseedge functional component? (Choose two.)

Refer to the exhibit. A GRE tunnel must be configured between routers RTA and RTB. Assume that router RTB has been correctlyconfigured. Which command would correctly configure router RTA to encrypt traffic that is destined for router RTB?

Refer to the exhibit. A network administrator is troubleshooting a recent OSPF stub configuration between R3 and R4. The only routesthat should appear on the routing table for R4 are intra-area routes and the default route. However, interarea routes are also appearing.What must the administrator do to fix this problem?

What is typically deployed to support high-speed transmissions of data to SOHO cable modems?

Which functional component of the Cisco Enterprise Architecture is responsible for hosting internal servers?

Refer to the exhibit. After configuring the IPv6 manual tunnel, a network administrator tries to verify the configuration from R1. Which IPaddresses should be included in the extended
ping
command in order to verify the status of the tunnel?

Refer to the exhibit. The route map LOAD_BALANCE has been applied to the FastEthernet interfaces of R1, and all interfaces are up. R1uses two default static routes to reach the Internet via ISP1 and ISP2. Which traffic will be sent to the null 0 interface by the route map onR1?

Which two EIGRP and MPLS implementation statements are true? (Choose two.)

Refer to the exhibit. Which two commands need to be used on R1 and R2 to create a virtual link to and from area 0? (Choose two.)

Refer to the exhibit. Router R1 is seeing routes that are advertised by router R2, and R2 is seeing routes that are advertised by R1.Which two statements are true when using EIGRP and an L3 MPLS VPN? (Choose two.)

Which two statements accurately describe the RIPng routing protocol? (Choose two.)

Refer to the exhibit.
access-list 111 permit ip 10.0.0.0 0.255.255.255 any

route-map net-10 permit 10

match ip address 111

set interface FastEthernet 0/1
Where would the system administrator apply the above configuration to establish policy-based routing that directs packets from the10.0.0.0/8 network through the R2 router to the Internet?

What does the log message
%DUAL-3-SIA: Route 10.1.2.0/24 stuck in active state in IP-EIGRP 24
mean?

Refer to the exhibit. The RIP routes must be injected into the OSPF domain. Which command will perform external routesummarization?

Multiple paths exist in the BGP table. Assuming the weights are the same, what will the next determining factor be?

On an OSPF multiaccess network, which multicast address must a non-DR router use to send an LSU packet that contains new link-state information?

Refer to the exhibit. Which route redistribution statement is true?

Refer to the exhibit. Based on the configuration in the exhibit, which statement is true?

Refer to the exhibit. RTA, RTB, and RTC are connected through Frame Relay. RTA advertises network 180.80.0.0 to RTC with a nexthop of 170.70.20.3. When RTC attempts to reach network 180.80.0.0, the routing fails. What should be configured under the BGProuting process to remedy the problem?

Refer to the exhibit. Which tunnel type should be configured on router R2 in order to establish connectivity between the two IPv6islands?

Which access technology would be the most insecure to use when interconnecting a branch site?

Refer to the exhibit. Which OSPFv3 configuration statement is true?

How does OSPF exchange routing updates when the
passive-interface
command is applied?

Which two tasks should be conducted during the PPDIOO Prepare phase? (Choose two.)

Which three features are commonly supported at the distribution layer of the Cisco hierarchical network model? (Choose three.)

Refer to the exhibit. Which set of features corresponds accurately to the Cisco Hierarchical Network Model as represented by the diagram?

Refer to the exhibit. An administrator is troubleshooting an adjacency problem between two OSPF routers. From the debug output, whatis most likely the cause of the problem?

Refer to the exhibit. A network administrator has configured EIGRP authentication between routers R1 and R2. After the routing tablesare reviewed, it is noted that neither router is receiving EIGRP updates. What is a possible cause for this failure?

Which two variables must match between two OSPF routers to form a neighbor adjacency? (Choose two.)

Which two statements are true of policy-based routing (PBR) as a path control tool? (Choose two.)

How do EIGRP routers establish and maintain neighbor relationships?

Refer to the exhibit. The BGP sessions are established between all routers. RTC receives route updates for network 170.10.0.0 fromautonomous system 300 with the weight attribute set to 3000. RTB learns about network 170.10.0.0 from autonomous system 200 with aweight of 2000. Which router will be used by RTA as a next hop to reach network 170.10.0.0?

Refer to the exhibit. RTA cannot establish an EBGP session with RTC in autonomous system 100. Which configuration command will fixthe problem?

Refer to the exhibit. OSPF and OSPFv3 have been configured on routers R1 and R2. However, they can exchange routing updates forOSPF but not for OSPFv3. What additional step should be taken to remedy the problem?

A router has EIGRP configured as the only routing protocol. In what way does EIGRP respond if there is no feasible successor route to adestination network and the successor route fails?

The IPv6 autoconfiguration feature enables a PC to automatically connect to an IPv6 network. What type of IPv6 address allows a PChost to send a router solicitation message requesting a prefix for stateless autoconfiguration?

What is a characteristic of an IBGP session type?